Some Tips For Shelf Installation

Aug 06, 2020 Leave a message

1. Open the hook box and you will find a transparent self sealing bag that contains the necessary internal hexagonal wrench, screws, and other accessories for installation. The internal hexagonal wrench is used for connecting the upper and lower columns, and screws and other accessories are used for installing the lightbox and connecting the columns and cabinets.
2. Here's a special mention: column connectors. In the past, some customers would unscrew the internal hexagonal screws on the connectors and then fix them from outside the column. This installation is incorrect. Our design is based on the principle of convenient installation by customers. The screws on the connectors do not need to be unscrewed, just insert them into half of the position inside the lower column and tighten them with an internal hexagonal wrench, then insert them into the upper column and tighten them, The position of the screw is exactly facing the slot of the column. It should be noted that the screws must be screwed into place, so that when installing the panel, the hook of the panel will not touch the screws and prevent the panel from being inserted into the column slot.
3. Hole type exhibition stand, there is a hole in the back of the hole plate used to connect the hole plate to the hole plate. After the installation of the exhibition stand, only the screws and nuts provided by the exhibition stand need to be used to connect the two hole plates from the back to ensure the flatness of the panel and strengthen the load-bearing capacity of the products placed.
4. The light tubes of the lightbox style exhibition stand are generally installed inside the column, which can avoid being damaged by compression during transportation. When installing, simply take out the integrated light tubes from the column, directly clip them into the slot of the lightbox, and plug them in. Because energy-saving lamps are provided, they won't be particularly bright when first turned on, but they will be fine in a few minutes. (If any issues are found with the power cord connection during installation, please do not use it for safety reasons and contact us promptly.)
5. The key to the cabinet door of the cabinet display rack should be taped to the side of the bottom of the cabinet door. Before installation, all components should be removed from the bottom of the cabinet, and then the key should be taken out to open the cabinet door. The screws and hex wrench required for installation should be removed from the hook box. To add, for ease of management, all cabinet door keys are now universal, so there is no need to worry about not being able to open the cabinet door after exchanging keys.
6. In addition, if the ground is uneven, the height of the exhibition stand can be adjusted by adjusting the screws at the bottom of the column to achieve a balanced state of the exhibition stand.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry